Error Messages in MODEM
Error 602 : The port is already open.
Cause :
Your modem is being used by another Dial-up Networking connection. The error message may be displayed even if no other communications program is currently using the modem you are attempting to use.
Solution :
First thing is to cold boot your computer. If the problem persists, press Ctrl-Alt-Del on your keyboard and End Task on Rnaap and retry.
Error 629 : You have been disconnected from the computer you are dialing.
Cause and Solution:
Make sure your settings are properly configured.Change the authentication to Clear Text under Security.Lower the connection speed under Modem Configuration.Disable hardware flow control under Modem Configuration.Disable modem error control under Modem Configuration.Disable modem compression under Modem Configuration.Disable PPP LCP extensions.Disable IP header compression.Check DNS configuration.Check the user name and password syntax.Connect using a Terminal window.Contact the modem's manufacturer for updated drivers.Have the phone company check the phone lines.
Error 630 : The port was disconnected due to hardware failure.
Cause:
There is a problem with configuration and/or installation of the modem. There is a conflict between your modem and another device on your computer.
Error 640 : A NetBIOS error has occurred.
Cause :
Your Modem Speed Software CompressionModem CompressionNoisy Phone LinesServer Problems
Solution :
Reduce your modems speed.Uncheck "allowed software compression."Have your phone lines checked.
Error 645 : Dial-Up Networking could not complete the connection to the server. (Internal Authentication Error)
Cause :
This could be caused by the following:Winsock.dll, wsock32.dll not installed or corrupted.Require encrypted password option is enabled.Dial-up adapter components are damaged or missing.Corrupted installation of Dial-Up Networking.
Solution :
Your best solution is to re-install Dial-Up Networking.
Error 650 : The computer you have dialed does not respond to a network request.
Cause :
This could be a problem with the ISP’s server.
Solution :
You may need to reinstall Dial-Up Networking
Error 659 : The media.INI file refers to an unknown device name.
Cause :
These errors can occur if one or more of the Dial-Up Networking configuration files is missing or damaged.
Solution :
Remove and reinstall Dial-Up Networking.
Error 676 : The line is busy. Try Again Later.
Cause :
This could be cause by the following:This problem can occur if you attempt to connect to your ISP using Microsoft Outlook Express.Your ISP cannot allow anymore connections. Try again later.
Solution :
Connect using Internet Explorer.Try to connect again.
Error 678 : The computer you are dialing is not answering please try again later.
Cause :
The most common cause for this is you are not dialing the right number.Corrupted modem driver.
Solution:
Reinstall your modem drivers.
Error 680 : No dial tone.
Cause :
This could be caused by the following:Unclaimed messages in your voice mail.Modem phone cord plugged into the wrong jack on the back of your computer.No dial tone on your phone line
Solution :
Put 2 comas in front of phone number.Do you have voice mail? Get your messages.Disable wait for dial-tone.Switch the phone cord connected to the Modem.Switch the port the phone cord is connected to.
Error 691 : The computer you are dialing in to cannot establish a Dial-Up Networking connection. Check your password, and then try again.
Cause :
This could be caused by the following.This is usually a password error.If you are dialing from a shortcut to your ISP and the Dial-Up Networking connection does not exist.
Solution :
Retype your username and your password and try again.Delete the shortcut to your ISP and make a new connection.
Error 720 : Dial-Up Networking could not negotiate a compatible set of network protocols.
Cause and Solution :
Check to make sure that you have TCP/IP, Dial-up Adapter and Client for Microsoft Networks Installed.
Post a Comment